This Tech Tips video explains how to properly install and secure the MRKS and MRK8 kits, ensuring correct clip orientation, secure motor installation, and proper end cap tightening.
Step 1: Attach the clip to the exit device, ensuring the forks point toward the head of the device, with the flat side up.
Step 2: Insert the yoke into position and align the pin, securing it with clips on both sides.
Step 3: Secure the motor by threading the screws from the back side into the appropriate holes, ensuring a stable fit.
Step 4: Pinch the bar down, flip the device over, and align the kit with the unthreaded holes before securing it with screws.
Step 5: Ensure the kick-outs on the kit fit into the extrusion groove to add strength and prevent unnecessary movement.
Step 6: If the end cap is loose, remove the push pad front, slide the piece back, and tighten the end cap screws.
Step 7: Reassemble the device by reversing the previous steps, ensuring all screws and pins are secure.